Finishing
Concrete curing with BestCure compound
BestCure SS015 is a polysilicate curing compound sprayed directly onto fresh concrete to form a thin microcrystalline film that seals surface pores and retains moisture throughout cement hardening.
Public technical guidance
This page is selection and sequencing guidance, not a project method statement. The current product TDS, approved design, site assessment and trial application take precedence; structural anchors, cracks, water-retaining structures and other safety-critical work require qualified technical review.
Applicable for
- Replacing water curing for concrete right after pouring
- Concrete cast under harsh conditions or demanding work items
- Mass concrete pours requiring good curing to limit surface cracking
- Tunnel concrete works
- Floor slab concrete needing a uniform surface color
Substrate requirements
- The concrete surface must be clean, free of dust, mud and grease
- No standing water on the surface during application; for horizontal surfaces wait until all bleed water has evaporated
Step-by-step procedure
- 1
Vertical surfaces: dampen and spray-coat
After stripping the formwork, evenly dampen the whole concrete with clean water and let it drain. Apply BestCure SS015 with a sprayer (preferred) or a brush, fully covering the entire surface.
- 2
Horizontal surfaces: spray right after floating
Spray BestCure SS015 immediately after floating the surface, once all bleed water has evaporated. Keep no standing water, never apply below the guided dosage, and apply as early as possible once the concrete is ready.
- 3
Protect the sprayed surface
Protect the fresh application from rain, ponding, dust and mechanical damage. In hot sun or drying wind, shading and supplementary curing must follow the approved concrete-curing plan rather than one generic temperature threshold.
- 4
Clean the tools
Clean application tools and equipment with clean water right after finishing the work, before the material hardens.
BestCure SS015 coverage is 8 – 12 m²/L depending on texture and absorption; spray evenly to full coverage when the concrete begins to firm and bleed water has evaporated.
Common questions
Which compound should I use to cure freshly poured concrete?
Use BestCure SS015, a polysilicate-based curing compound. Sprayed onto fresh concrete, it forms a thin microcrystalline film that seals surface pores, cuts water evaporation and lets the cement hydrate fully.
What is the dosage of BestCure SS015?
About 8 – 12 m²/L depending on texture and absorption. On horizontal concrete, spray only after bleed water evaporates, with even coverage and no standing water.
Can subsequent coatings be applied over a surface cured with BestCure SS015?
Yes. BestCure SS015 is specifically intended for surfaces that will receive further construction steps, and it does not break down and impair performance the way resin-based curing compounds can.
Need advice for your project?
Bestmix engineers help you choose the right system and consumption — free of charge.