BestProtect EP712

• BestProtect EP712 has low viscosity and high penetration capability, making it suitable for forming protective and anti-corrosion coatings on steel, wood, as well as concrete and mortar substrates.

• Structures frequently exposed to aggressive environments, seawater, chemical corrosion or mechanical abrasion should be coated with BestProtect EP712 before being put into service.

• High penetration allows the material to deeply infiltrate into the substrate.

• Excellent adhesion to various construction materials, including metal surfaces.

• Enhances gloss, aesthetics, and extends the service life of structures.

• High resistance to mechanical abrasion, chemical corrosion, and aggressive environments.

• Provides waterproofing and surface stain resistance.

• Easy application using simple tools such as brushes, rollers, or spray equipment.

• Can be applied directly onto damp surfaces.

• Environmentally friendly.

SURFACE PREPARATION:

• The substrate must meet the minimum strength requirements (compressive strength ≥ 20 MPa, tensile strength ≥ 1.5 MPa).

• The surface must be clean and free from oil, grease, dust, and contaminants. No standing water is allowed, and surface moisture must not exceed 16%.

• The substrate should be well-ventilated during application.

APPLICATION PROCEDURE:

Coating system:

• For porous or pitted surfaces, repair with BestBond or BestRepair before applying BestSeal EP627.

• For highly absorbent, weak or porous substrates, apply a minimum of 3 coats of BestSeal EP627 or until full saturation is achieved without ponding.

• For smooth, dense surfaces with moderate roughness, apply a minimum of 2 coats of BestSeal EP627.

Mixing:

• Add component B into component A according to the specified ratio. Use an electric mixer or suitable mixing equipment (300–400 rpm) to mix for approximately 3 minutes or longer until a homogeneous mixture is achieved.

Application:

• Can be applied using a brush, short-nap roller, or spray equipment.

Notes:

• Do not use material that has exceeded its pot life.

CLEANING:

• Use clean water and soap to clean tools immediately after use and before the material begins to cure. Rinse again with clean water.

SAFETY:

• Both components are non-hazardous and non-flammable but may cause allergic reactions on sensitive skin. Protective gloves, masks, and safety goggles are recommended during application.

• In case of contact with eyes, nose, mouth, etc., rinse immediately with plenty of clean water and seek medical attention at the nearest healthcare facility.