BestLatex R114

• Bonding slurry (for waterproofing or as a bonding agent between old and new concrete).

• Thin repair mortar for surface finishing.

• Waterproof rendering mortar for surface protection.

• Floor screed mortar with enhanced abrasion resistance.

• Concrete repair mortar.

• Abrasion-resistant topping layer.

• Tile adhesive mortar.

• Masonry mortar and waterproof plastering mortar.

• Excellent bonding and adhesion.
• Minimize shrinkage of volume during curing process.
• Increase elasticity for sand and cement mortar.
• Increase the maximum waterproofing capacity for surfaces that are frequently exposed to water.
• Increase chemical corrosion resistance and abrasion resistance.
• Stability in terms of chemical and physical properties.
• BestLatex R114 is an irreversible polymer emulsion, after application, BestLatex R114 develops a membrane-bonding network with silicate-derived surfaces when exposed to it so it is not converted to emulsion even under high alkalinity conditions.
• Non-toxic when cured , so it could be applied for waterproofing mortar directly contact with domestic water.
• Increase the intensity of the plaster.
• Suitable for making mortars and patches where thin finishing layers are required.

Surface preparation:​

• Surface must be clean, remove dust, laitance, grease, and any other contaminants.

• If surface is not rough enough, roughen surface by using suitable mechanical methods before application.

• Saturate of entire surface by clean water but no water remains.

Material preparation:

• Aggregation (sand) must be selected carefully and clean, the sand size must be suitable with the width of grout and requirement of surface fineness when application.

For Waterproofing and old to new concrete bonding slurry: 

Mixing ratio:  1 L BestLatex R114 + 1 L Water + 4 kg Cement = 3,3 L Slurry 

Application:

• Pour the cement into the mixture BestLatex R114 and water (prequantified), use a paddle to mix until homogeneous. Apply the connected layer of 1 - 2mm thickness on the water-saturated surface first and pour new concrete or plaster the waterproofing mortar as soon as the cement slurry-BestLatex R114 is wet.

Consumption:

• 1 liter of BestLatex R114/ approx. 4 m² applicable

For waterproofing mortar:

Mixing ratio:

1 L BestLatex R114 + 3 L water + 6,5 kg Cement + 19,5 kg sand= 30 kg mortar  

Application:

• Apply the waterproofing mortar layer as soon as the waterproofing slurry layer is still wet. 

Consumption: 

• 1 liter of BestLatex R114 / 1.5 m² / 1 cm of thickness 

Caution: 

• BestLatex R114 must always be used with cement, should not be used alone as an independent adhesive agent.