BestHard LS110
One-component, active lithium silicate compound that strengthens the surface hardness of concrete
Advantages:
Pre-mixed, one-component, requires no further preparation, making it easy to use.
High penetration and strong activity.
Significantly increases hardness, abrasion resistance, and dust generation on concrete surfaces.
Enhances cleanability and prevents contamination of concrete surfaces.
Colorless, odorless and does not alter the color of the concrete surface.
Suitable for indoor and outdoor use.
Non-toxic and environmentally friendly. Maintains uniform color on hardened surfaces.
BestHard LS110
Technical summary
Category
Floorings
One-component, active lithium silicate compound that strengthens the surface hardness of concrete
BestHard LS110 is an active Lithium Silicate compound, a single-component compound that strengthens the surface hardness of concrete, especially for foundation and floor concrete, increasing abrasion resistance and preventing dust generation during concrete use.
Technical documents
Product data
| Composition | Lithium silicate |
|---|---|
| Form | Transparent liquid |
| Consumption | 10 ÷ 20 m²/liter (depending on surface condition) |
| Density | 1.10 ± 0.05 kg/lít (@ 25°C) |
| pH | 10 ÷ 12 (@ 25°C) |
| VOC | 0 g/l |
| Packaging | 25 liters/can; 210 liters/drum; 1000 liters/tank |
| Storage | Stored in a cool, dry place with an ambient temperature of 5°C - 35°C |
| Shelf-life | 24 months from the date of manufacture |
Applications
Industrial workshops, warehouses, garages, parking lots, and other areas require high levels of abrasion resistance and dust prevention for concrete surfaces.
Advantages
Pre-mixed, one-component, requires no further preparation, making it easy to use.
High penetration and strong activity.
Significantly increases hardness, abrasion resistance, and dust generation on concrete surfaces.
Enhances cleanability and prevents contamination of concrete surfaces.
Colorless, odorless and does not alter the color of the concrete surface.
Suitable for indoor and outdoor use.
Non-toxic and environmentally friendly. Maintains uniform color on hardened surfaces.
Application instruction
SURFACE PREPARATION:
Concrete surfaces must be thoroughly cleaned of contaminants such as dust, oil, grease, paint, old coatings, and curing compounds using appropriate tools and equipment.
To facilitate deep penetration, the concrete should be dried to a suitable moisture level (≤ 8%).
APPLICATION PROCEDURE:
Use a roller or low-pressure spray to evenly apply the material onto the concrete surface at a recommended coverage rate of approximately 0.08–0.10 liters/m², depending on the condition of the substrate.
After about 30 minutes (once the material has fully penetrated into the concrete), apply a second coat at a rate of 0.03–0.05 liters/m² to treat any insufficient areas.
If surface polishing is required, use BestSlick G85 polishing compound to enhance waterproofing, stain resistance, and aesthetic appearance of the concrete surface.
CLEANING:
Clean tools and equipment with clean water immediately after application and before the material cures.
SAFETY INSTRUCTIONS:
The product is alkaline and may cause irritation to sensitive skin upon prolonged contact. Protective gloves, masks, and safety goggles are recommended during application.
In case of contact with eyes, nose, mouth, etc., rinse immediately with plenty of clean water and seek medical attention at the nearest healthcare facility.
BestHard LS110 is an active Lithium Silicate compound, a single-component compound that strengthens the surface hardness of concrete, especially for foundation and floor concrete, increasing abrasion resistance and preventing dust generation during concrete use.