BestBond EP750MW

• Permanent bonding for cracked or fractured concrete structures such as: floors, foundations, tie beams, load-bearing beams, basement walls, etc.

• This product is also used to repair hairline cracks and as a protective layer for steel structural components such as anchor bases...

• BestBond EP750 creates a bonding layer with significantly higher tensile strength than concrete. In addition, the product offers the following advantages:

• Easy and simple application, allowing for application at low temperatures.

• Easily fills small cracks, maximizing the restoration of original strength.

• Rapid strength development, shortening the time required for the structure to be put into use.

• Very high adhesion and tensile strength compared to concrete.

• Solvent-free, non-toxic, and environmentally friendly.

SURFACE PREPARATION:

• The crack surfaces must be clean and free from loose contaminants.

• Dust, grease, algae, moss, and other impurities must be removed by suitable mechanical preparation methods.

APPLICATION PROCEDURE:

Mixing / Injection Preparation

Use a concrete drilling machine to drill holes (minimum depth 30 mm) for installation of injection ports (one-way valves) at the lowest point of the crack.

Use BestBond EP753 to fix the injection ports and seal the remaining exposed crack surface.

Use an automatic injection gun or specialized high-pressure injection pump to inject the material until the crack is completely filled (material exudes from the highest point of the crack).

BestBond EP750MW will achieve full curing after 07 days from the date of application.

Depending on specific project conditions, other suitable application methods may also be adopted.

Note

Do not use any mixed material that has exceeded its allowable working time.

CLEANING

Use BestThinner SC01 or other suitable solvent to clean tools immediately after use and before the mixture begins to harden.

Then wash again with clean water and soap.